The Speedflip is an electronic plate flipper, a simple device and a great start for anyone interested in car modifying. A great low-tech solution for giving a car that secret agent feel.

There is 4 different flip plate systems to choose from, 1) single flip plate operated by remote key fob for car or bike, 2) single plate operated by switch more suited to bikes. 3) 2 plate system for car or lorry & bike, it will flip your front and rear plates down at the same time 4) you can order either to operate the Speedflips by remote key fob or by a switch, the choice is yours.

Over the last six years, those involved with Speedflip have listened to the feedback and comments and used such valuable information to further improve the Speedflip's design and operation. The one thing everyone wanted was a system that is discreet so we designed the Speedflip to be the smallest on the market to date it measures just 2cm thick 8cm high & 14cm wide no other flip plate is as discreet as Speedflip. We also made the internals water proof, & weather proof.

Now the Speedflip is laser cut from a light and durable aluminum with precut holes, powder coated in a low-gloss matte black finish, and made for easy installation in mind. With simple instructions, and as little as 15-20 minutes, the Speedflip is uniquely designed to be attached to any vehicle to flip downwards or upwards (recommended upwards for motorcycles) with its new 12 volt three wire system. No special outside power source is needed to activate the Speedflip (which runs off of a vehicle's ignition live wire).

Speedflip is guaranteed for 12 months from date of purchase.

The Speedflip can quickly flip a plate in as little as (0.09 seconds ), and the internals ensure that when the Speedflip returns to its normal position, it stays closed and will look like a normal number plate.

A switch operated version is available for Motor Cycles. Its identical to the remote version apart from a switch is added to operate the Speedflip. More suited to Bikers.

The internals of the Speedflip are specially designed, and because the Speedflip is operated by remote key fob, each key fob can be designated to flip specific Speedflip plates. This means one key fob can be assigned to flip a front and back plate, and that you and your friends can both use Speedflip with no accidental flipping of each other's plates. The key fobs will even alert the driver when its batteries are low and in need of replacement.

An average kit comes with the Speedflip and its internal mechanism, an LED (that warns when the Speedflip is in an open position), a key fob, and easy-to-read instructions. Additional Speedflips and key fobs can be ordered.

Should any difficulties or questions about the product arise, feel free to check the Contacts for help and information.

Speedflip is an electronic flip plate designed and manufactured in the UK and is protected by a "Registered Design". Any blatant copy of its design, commercial reselling, or usage of individual pieces in other similar devices will not be tolerated and legal action will be taken. As stated in the site's disclaimer below every page, the Speedflip is intended to be used for show and off road purposes only. Purchasing the product immediately entitles that the designer, manufacturer, and its site take no responsibility for a purchaser's use of the Speedflip and will not be held liable for any mis-use of the product.